FANUC SR-6iA Standard Cover and Bellow Kit
SKU: ANU-SCK-SR6
The same FANUC partnered sealing system, sized for the larger SR-6iA SCARA robot and the heavier duty cycles it carries in packaging, assembly, and material handling cells.
- Nylon 12 upper shield encloses the upper mechanism with pneumatic pass-through fittings
- FDA approved translucent silicone bellow seals the vertical quill through its full movement
- Max stroke of 180 mm with only 30 mm stroke loss on the SR-6iA
- Custom fit to existing assembly points with all hardware included
- Standard and industrial kit options available
- Running a dusty cell? Also available with dust filters or as a custom build
Standard Clean Room
The sealed kit as standard. A Nylon 12 shield and a translucent silicone bellow seal the upper mechanism and the quill, with a single 6 mm breathing port at the top.
You are viewing this versionWith Dust Filters
For dusty cells. A filtered front plate plugs the top port and breathes through four 50 µm filters, so dust never reaches the greased quill.
View this versionCustom
Configured to your application: cover size, air fitting, cable gland and plug sizes, and a low moisture material for low dew point environments.
View this version
Heavier Cycles, Same Protection
Higher payload SCARA cells in packaging, electronics, plastics, and food environments where cleanliness around moving parts is a requirement rather than a preference. For the compact SR-3iA, see the SR-3iA kit.
The Sealed Kit as Standard
The standard kit seals both the upper and lower sections of the SR-6iA. A Nylon 12 shield encloses the upper mechanism and carries three pneumatic pass-through fittings, while a translucent silicone bellow seals the vertical quill through its full stroke. The cover breathes through a single 6 mm port at the top of the front plate, which suits clean room and light dust environments.
- Three pneumatic pass-through fittings, 4/6 mm, with optional communication cable fittings
- Dedicated connection for internal negative pressure
- Installs on the existing assembly points with all fasteners included
- Available as a standard or an industrial kit
- Six-month limited warranty
Technical Specifications
| Part numbers | ANU001632 (SCK-SR6-STD, standard kit) ANU001612 (SCK-SR6-IND, industrial kit) |
| Weight | approx. 1100 g standard kit, approx. 1140 g industrial kit |
| Pass-through ports | 3 |
| Pneumatic fittings | 4/6 mm |
| Length | 252 mm |
| Width | 120 mm |
| Height retracted | 457 mm |
| Height extended | 636 mm |
| Max stroke | 180 mm |
| Stroke loss | 30 mm |
| Bellow | FDA approved translucent silicone |
| Materials, standard kit | PA, SS, Ni, NBR, VMQ, CRM |
| Materials, industrial kit | PA, SS, Ni, NBR, VMQ, CRM, CU |
| Compatible robots | FANUC SR-6iA |
| Versions | Standard clean room |
| Warranty | Six-month limited |
Weights are approximate and may vary by up to 10 percent depending on version and options. Stroke loss is based on the FANUC North America published stroke length as of 2025-06-20.
Protect the SR-6iA that carries your heaviest cycles
Our standard clean room kit, ready to install on the robot's existing assembly points. Tell us your application and we will confirm the fit.
